Home News Content

Three Monitoring Indicators For Chiller Compressor Lubricant?

Jul 10, 2017

The lubricating oil used in the compressor is critical, and the detection of oil and its replacement cycle are closely related to the process control in the production process. If the compressor system in the use of the process of the condenser, evaporator, and the system piping cleanliness can control the better, then relatively can enter the compressor pollutants is relatively small, in its detection And the maintenance cycle can be relatively extended. Here to understand the main indicators of lubricants in the main monitoring indicators.


three monitoring indicators for compressor lubricants 


1, PH value indicators:


If the lubricating oil in the compressor is acidified, it will cause the motor to be directly affected and the service life will be reduced. Therefore, it is necessary for the maintenance personnel to check whether the acidity of the lubricating oil is qualified on a regular basis. Under normal circumstances, if the acidity of the oil reaches PH6 below, can no longer continue to use, but must immediately replace the new lubricants. If the conditions do not allow the degree of acidification of the lubricating oil, then the system should be regularly replaced by the dry filter to ensure that the system dryness to maintain the normal state, is conducive to maintaining the normal value of lubricating oil to prevent acidification.


2, pollution indicators:


Good quality low-cost compressor host should use the type of special lubricants, but also to ensure that there is no impurities in the lubricating oil, because the small impurities in the process of running the motor will cause wear and tear, so if you find 100ml of lubricants In the debris more than 5mg, then the proposed timely replacement of new lubricants.


3, water content:


Water will make the oil acidification reaction, so in use if the oil in the oil found more than 100ppm, need to replace the frozen oil. Also in the storage of bottled lubricants should pay attention to quiet bucket, to avoid moisture and impurities into the pollution.


The above three aspects is to monitor the Hanbell compressor lubricants some important indicators. As the lubricating oil plays an important role in the operation of the compressor, it is important to ensure the quality of the lubricating oil, regular replacement and replenishment of the lubricating oil in order to ensure the normal operation of the engine, with better air compression effectiveness.